• Non ci sono risultati.

Thermal performance of the new hall of the historical hospital in Florence

N/A
N/A
Protected

Academic year: 2021

Condividi "Thermal performance of the new hall of the historical hospital in Florence"

Copied!
1
0
0

Testo completo

(1)

Thermal performance of the new hall of the historical hospital in Florence

C. Balocco*,1, E. Marmonti1

1Dipartimento di Energetica, Università di Firenze *Corresponding author: via Santa Marta 3,F irenze, Italy Email: carla.balocco@unifi.it

The main aim of the present work is the study of the energy performances of the new hall of the Old St.Maria Nuova Hospital in the center of Florence (Italy). In particular this study aims to evaluate thermal, energy and

environmental performances of the refurbishment project for the new hall of the historical hospital and to evaluate the significant reductions of energy consumption obtained. Transient simulations were carried out of the 3D model of the hall to analyse the air flow patterns, distribution and velocity, provided by an existing typical fan-coils air

system. The present study highlights the importance of CDF-FEM simulation to predict and analyse the energy and thermal performance of the system (thermal buffer called hot room), when experimental measurements cannot be carried out due to high costs and time needed.

Riferimenti

Documenti correlati

An analysis of the asymmetries in different regions of the phase space is made for the first time and the results are consistent with CP conservation. Relatively

Regarding the velocity distribution, Figure 4.7, transverse section taken exactly in the middle of the barrel, shows that the air velocity is higher in the upper part of the

Length of both surgical and VPAC times affected cell viability: the critical surgical time was set around 1 hour and 30 minutes, while cells preserved a good viability when kept

Other forms of enforcement, on the other hand, lend themselves to almost complete automation, such as in the case of enforcement over (at least certain types of)

Analysis of the measurement results demonstrates unambiguously the impact of the roof structure (used building materials) and their design thermal resistances on the values

They used the time log and decrement factor for a building wall including different configurations of multilayer thermal insulation.. In this work, the study was devoted to

Ventilation load Supply heat quantity to underfloor Supply heat quantity to room Heat absorption to heat storage rise of underfloor space temperature Increase of heat transmission

10:20 - 10:30: Ambassador; Permanent Representative of OECD, President of YENADER Kerem Alkin, Ph.D Speech of Honors:. 10:30 - 10:50: President of International Energy Agency