• Non ci sono risultati.

Degradation of phenol and benzoic acid in the presence of a TiO2-based heterogeneous photocatalyst

N/A
N/A
Protected

Academic year: 2021

Condividi "Degradation of phenol and benzoic acid in the presence of a TiO2-based heterogeneous photocatalyst"

Copied!
1
0
0

Testo completo

(1)

This paper reports the results of a study on the titanium dioxide Wackherr’s ‘‘Oxyde de titane standard’’, which shows very interesting photocatalytic activity. Produced for cosmetic purposes as a white pigment, its features make it very interesting in the field of heterogeneous photocatalysis. The results obtained with this photocatalyst are compared with the behaviour of the well-studied and widely used TiO2 Degussa P25 under the same conditions. In particular, the TiO2 Wackherr

induces relevantly faster phenol degradation than P25 when high photocatalyst loading is used (up to 2.00 g l-1), as phenol degradation rate in the presence of TiO2 Wackherr continues to increase

with increasing photocatalyst loading. This is most likely due to the lower radiation scattering in the UV region of TiO2 Wackherr when compared with Degussa P25, which is linked with the higher

particle size of TiO2 Wackherr. The initial phenol degradation rate by TiO2 Wackherr as a function

of phenol concentration has a maximum for [phenol] ≈ 3x10-4 M, and decreases for higher concentration values. The addition of fluoride ions to TiO2 Wackherr at pH 3.7 increases phenol

degradation rate, as already found for Degussa P25. The increase is more relevant for higher phenol concentration values and makes the maximum as a function of phenol concentration to disappear. Comparable results are also obtained when benzoic acid is used as a substrate, with some differences from phenol that can be accounted for by benzoic acid more strongly interacting with the surface. The use of TiO2 Wackherr in heterogeneous photocatalysis can be desirable when high

Riferimenti

Documenti correlati

The 2-CP removal efficiency by adsorption process using TiO 2 bare catalyst was only about 25 % while the 2-CP removal was best removed by activated carbon (removal efficiency 70

The degradation rate of phenol between 50-150 h for phenol concentration of 900 mg/L and 30 mg/L of Cr(VI) in Figure 4a is significant but Cr(VI) response in Figure 3a for the

In this study, the photocatalytic degradation of phenol in the presence of titanium dioxide (TiO 2 ) nano-particles and UV light was investigated, with emphasis on the

Finally the influence of the presence of phenol on the reduction of Cr(VI) was investigated under the following parameters: chromium solution concentration of 20 ppm, 0.02

The kinetics of ultrasonic degradation has been investigated, and the model for estimating the apparent degradation rate constant of methylene blue as model hazardous organic

Figure 3: Effect of N-TiO 2 thermal treatment in the photocatalytic degradation of phenol (catalyst – N-TiO 2 (1g of urea), phenol initial concentration – 12 ppm, phenol volume –

The photocatalytic activities of BiOCl, AgCl/BiOCl and Ag/AgCl/BiOCl composite were evaluated by monitoring the degradation of phenol under UV and visible light irradiation..

Typical samples of pure TiO 2 , SiO 2 and their composites were characterized using N 2 - physisorption (BET surface area, BJH pore size distribution and total pore volume), X-ray