178
7 . Bibliografia
1) Kanakaji Chittineni – “Functionally graded syntactic foams”, 2009 (Thesis submitteted to the to the Graduate Faculty of the Louisiana State University and Agricultural and Mechanical College in partial fulfillment of the requirements for the degree of Master of Science in The Department of Mechanical Engineering)
2) Hiroyuki Mae, Masaki Omiya and Kikuo Kishimoto - “Effects of strain rate and relaxation rate on elastic modulus of semi - crystalline polymer (Transactions of JASCOME Vol. 7, No. 2 (March, 2008), Paper No. 06- 080317)
3) Nikhil Gupta, Raymond Ye and Maurizio Porfiri – “Characterization of vinyl ester-glass microballoon syntactic foams for marine applications” (Not Yet published, under review)
4) Hiroyuki Mae, Masaki Omiya and Kikuo Kishimoto – “Effects of Strain Rate and Density on tensile behavior of polypropylene syntactic foam with polymer microbaloon” (Materials Science and Engineering A 477 (2008) 168-178)
5) Marc Andrè Meyers and Krishan Kumar Chawla “Mechanical Behaviour of Materials” (Cambridge University Press), pp 639-650
6) George T. (Rusty) Gray III and William R. Blumenthal, Los Alamos National Laboratory – Split Hopkinson Pressure Bar Testing of Soft Materials (ASM Handbook – Volume 8, Mechanical Testing and Evaluation pp. 1093 – 1114) 7) Sia Nemat – Nasser, University of California, San Diego “Introduction to
High Strain Rate testing” (ASM Handbook Vol.8, 2000, pag 939 – 943) 8) George T. (Rusty) Gray III, Los Alamos National Laboratory “Classic Split-
Hopkinson Pressure Bar Testing (ASM Handbook Vol.8, 2000, pag 1027 – 1068)
179 9) Marco Peroni, Politecnico di Torino “Experimental methods for material characterization at high strain-rate:analytical and numerical improvements”, 2008, PhD Thesis.
10) Michael Adam Kaiser, Virginia Polytechnic Institute and State University
“Advancements in the Split Hopkinson Bar Test”, 1998, Master of Science in Mechanical Engineering Thesis.
11) Staab GH, Gilat A A direct-tension split Hopkinson bar for high strain rate testing. Exp Mech 313:232–235 (1991).
12) Noble, J.P., Goldthorpe, B.D., Church, P. e Harding, J., The use of the Hopkinson bar to validate constitutive relations at high rates of strain, Journal of the Mechanics and Physics of Solids, 47 (1999), pp. 1187-1206.
13) Sasso, M. “Caratterizazione di leghe metalliche ad alta velocità di deformazione” XXXIV Convegno AIAS, Milano 2005
14) Karl F.Graff, “Wave Motion in Elastic Solids” , Ohio State University Press, 1975
15) G.Diana, F.Cheli “Dinamica e Vibrazione dei Sistemi Meccanici”, 1993, UTET Università
16) N.Petrinic "Solid Mechanics (Paper C1B) – Impact Engineering, University of Oxford, Department of Engineering Science, 2005, Lecture Notes
